ELEC 3907 JeeNode v6 Arduino Based Microcontroller
Copyright © 2020 By: Shakeeb Abdullah - Carleton University
Welcome to ELEC 3907 3rd year project course. Below are a few tutorials with Arduino/JeeNode to get started.
Tutorial 2: Using Light-Dependent-Resistor (LDR) to Control an on/off LED Light
When the LDR is covered with the Paper the LED turns off. The threshold of the LDR will depend on the lighting and resistor used in series with the LDR.
Tutorial 3: Variable Blinking LED Using LDR
The rate of the LED changes depending on the amount of light received by the LDR. As the amount of light is increased on the LDR, the blinking rate of the LED decreases.
Tutorial 4: Controlling LED Using LDR Through RF
The LDR communicates with the LED (which turns on and off) through the RF of the two JeeNodes.
Tutorial 5: Variable Blinking LED Using LDR Through RF
The LED communicates with the LDR through the RF of the two JeeNodes. One JeeNode acts as a transmitter and the other as a receiver. The blinking rate of the LED depends on the amount of light received by the LDR.
______________________________________
Website Created By: Shakeeb Abdullah (Jan. 2020) - Carleton University
All JeeNode Tutorial Videos Produced By: Shakeeb Abdullah (Jan 2020)
JeeNode Image obtained from: https://www.digitalsmarties.net/products/jeenode
ELEC 3907 JeeNode Tutorial Videos
Tutorial 2: Using Light-Dependent-Resistor (LDR) to Control an on/off LED Light
When the LDR is covered with the Paper the LED turns off. The threshold of the LDR will depend on the lighting and resistor used in series with the LDR.
Tutorial 3: Variable Blinking LED Using LDR
The rate of the LED changes depending on the amount of light received by the LDR. As the amount of light is increased on the LDR, the blinking rate of the LED decreases.
Tutorial 4: Controlling LED Using LDR Through RF
The LDR communicates with the LED (which turns on and off) through the RF of the two JeeNodes.
Tutorial 5: Variable Blinking LED Using LDR Through RF
The LED communicates with the LDR through the RF of the two JeeNodes. One JeeNode acts as a transmitter and the other as a receiver. The blinking rate of the LED depends on the amount of light received by the LDR.
______________________________________
Website Created By: Shakeeb Abdullah (Jan. 2020) - Carleton University
All JeeNode Tutorial Videos Produced By: Shakeeb Abdullah (Jan 2020)
JeeNode Image obtained from: https://www.digitalsmarties.net/products/jeenode